- Joined
- Oct 2, 2015
- Messages
- 177
- Points
- 0
Basic Question
So I'm building a couple Laser66 leadlight pens and if you don't know how they are assembled it's shown below. I would need only the Black plastic switch board holder/ button support as shown below. You may think this sounds stupid, but when I bought the host, they only give one for each host. Too bad I screwed up and broke 2 of them. I still have 3 unbuilt hosts and 2 is basically junk because there's nothing to hold the switch in place therefore cannot finish assembly. See pics below.
The thing I need is ONLY the black plastic holder piece, so if anyone can make a Clone or "Copy" of the exact same thing, I will Pay for all expenses no matter what. If you have a 3D Printer please PM me the price and I'll give you the length, width, or even an real thing, will be given to you to clone. Thank you,
This is their site(Below)
This is their site(Below)
Assembly Pictures
Switch Holder or Button Support
(Switch NOT needed, Just the black plastic piece)
Last edited:
