- Joined
- Nov 4, 2013
- Messages
- 40
- Points
- 0
Edited
Last edited:
LPF Donation via Stripe | LPF Donation - Other Methods
Links below open in new window
ArcticMyst Security by Avery
Quick question.
- Thread starter BlackFire007
- Start date
Tmack
0
- Joined
- Oct 13, 2013
- Messages
- 2,478
- Points
- 0
Haha someone forgot to get wire at the store huh???
Yeah if the case wire isn't used then it should be fine.
Yeah if the case wire isn't used then it should be fine.
- Joined
- Nov 4, 2013
- Messages
- 40
- Points
- 0
All right thanks for the quick reply.... Do you know how long is too long when making the solder joint from my module to the driver. Im only using rosing core solder but no flux. Is this safe?
Tmack
0
- Joined
- Oct 13, 2013
- Messages
- 2,478
- Points
- 0
Yeah should be fine I don't use flux for quick connections. What do you mean long? Length of heat time, wire length?
Length of heat time is always just enough to do the job. Try to get the smallest diameter solder possible for your driver connections. I use .022 Since your module has pre connected leads, you shouldn't have to worry about overheating the diode.
As for the length of the leads, just enough so they will tuck in, but not so long where they will be a tangled mess inside the host.
Does that help, or am I missing the question?
Length of heat time is always just enough to do the job. Try to get the smallest diameter solder possible for your driver connections. I use .022 Since your module has pre connected leads, you shouldn't have to worry about overheating the diode.
As for the length of the leads, just enough so they will tuck in, but not so long where they will be a tangled mess inside the host.
Does that help, or am I missing the question?
Last edited:
