flexdrive v2 help please

hey guys

mainly because im lazy and i dont have a soldering iron, ive been putting off my PHR-803T build (flexdrive v2, 100mA, 803T in aixiZ module)

however, i am unsure of where to solder in the various components to the flexdrive since its relatively old technology now (lol)

so does anyone have a diagram or can anyone tell me where to solder what in?

thanks for any help

also can i use a 9V battery?

that is all... thanks guys

post a pic as clear as you can get it. cant use 9v with any flexdrive. its <5.5v.

edit: heres a crappy paint pic..

here is a picture of it and what i assume is the outputs based on your diagram and looking at one of jayrob's posts

EDIT: forgot to say tahnks for your help mate

Here's the link to the Version 2 manual, which can be hard to find now that version 4 is the standard.

thankyou fine sir, i was looking for the copy drlava sent me but i must have lost it lol

Bionic-Badger said:

Here's the link to the Version 2 manual, which can be hard to find now that version 4 is the standard.

Click to expand...

thanks Bionic-Badger that explaines a question I had but haven't asked about.
I recently ordered and recived two flex drives when they arrived they came with a tech sheet but the pic and directions did not match. I believe I must have got one of these old V2 data sheets with my V4 drives.

Best Regards Pyro... :eg: