- Joined
- Aug 30, 2008
- Messages
- 6,891
- Points
- 83
i was looking through a thread and realised i had screwed up on a set of lasers i helped a forum memeber with...
i built a red and BR from a GGW sled for a member, and totally forgot to strip the components off the stock driver, so the stock driver is still intact on the set of dorcy jr lasers....
so basicly the flex drive is being powered by the dorcy jr driver.
i'm just curious if the dorcy jr stock driver outputs enough voltage and current to properly run a flex drive......
basicly so i know if these lasers need to get fixed.
i built a red and BR from a GGW sled for a member, and totally forgot to strip the components off the stock driver, so the stock driver is still intact on the set of dorcy jr lasers....
so basicly the flex drive is being powered by the dorcy jr driver.
i'm just curious if the dorcy jr stock driver outputs enough voltage and current to properly run a flex drive......
basicly so i know if these lasers need to get fixed.