kilter
0
- Joined
- Jul 11, 2012
- Messages
- 600
- Points
- 28
Hello Everyone!!!
I found out a way to make a cool dust cap for a pen laser. Sadly it only works with the kind with a kalidiscope tip. Like this one: 200mW 532nm Mid-open Kaleidoscopic Green Laser Pointer Pen with 2AAA Battery at Laserpointerpro.com because it has the hollowed out front end. Here's what I did:I cut off the rubber tip.
Then trim it down and you're done! It should look like this:
[/url][/IMG]
Then insert like this:
[/url][/IMG]
And that's it. BONUS!!! If you turn the laser with it on, then you get a nice red reading light!!!
[/url][/IMG]
(by the way, the laser used was a regular laser pointer wrapped in electrical tape
Thanks for reading!
I found out a way to make a cool dust cap for a pen laser. Sadly it only works with the kind with a kalidiscope tip. Like this one: 200mW 532nm Mid-open Kaleidoscopic Green Laser Pointer Pen with 2AAA Battery at Laserpointerpro.com because it has the hollowed out front end. Here's what I did:I cut off the rubber tip.
Then trim it down and you're done! It should look like this:
Then insert like this:
And that's it. BONUS!!! If you turn the laser with it on, then you get a nice red reading light!!!
(by the way, the laser used was a regular laser pointer wrapped in electrical tape
Thanks for reading!
Last edited:
