oclaro 700 638nm first build advise.

paul1598419 said:

If you are going to buy your diode from DTR, you might as well get it with the driver set and attached. It will be a basically solder the wires to the contact board screw it into the heat sink and you are done. That diode doesn't need to be separated from the diode like higher power diodes are and it would be better this way. Also, take a page from my play book and always check the diodes pinout diagram. Never assume that you know how it should be wired.

Click to expand...

Richie89 said:

Awesome! So I guess my next question is that I've noticed that most all the diodes that DTR sells with an exception of 1 or 2 are all case not used, so does that mean they're almost all meant to be wired the same? I know IR and some 650-660s are different. Once again thanks so much VV for the help, I appreciate you all helping me so much for my first build

Click to expand...

Richie89 said:

You're definitely right man I've been looking at all of them just to get an idea, I've noticed on his site and a lot of reviews on here that DTR has made it easy by attaching all that stuff for you where as a long time ago I believe you had to do it all yourself. That's great for people like me. Haha, and to be honest I don't think I would be able to solder leads onto the diode pins without ruining the diode, I heard you had to be fast and flawless

Click to expand...

bdgreenb said:

There's no need to shy away from getting some diode pin solder practice. I've build tons of ~300mw 660nm just to hone my skills. Now I only kind of have stress freak outs when I'm soldering more expensive diodes. For now, stick to preattached drivers from Jordan, but don't poo poo the awesome feeling of building a build from scratch just my couple of pennies

Click to expand...

bdgreenb said:

There's no need to shy away from getting some diode pin solder practice. I've build tons of ~300mw 660nm just to hone my skills. Now I only kind of have stress freak outs when I'm soldering more expensive diodes. For now, stick to preattached drivers from Jordan, but don't poo poo the awesome feeling of building a build from scratch just my couple of pennies

Click to expand...

Chrisbee said:

I agree. Also if you have good solder, and some flux/tinner, You should only need to just tag the leads with the iron and the solder will flow onto them. I'd give it a shot on some random components first if you're nervous. It's not too difficult if you've got a steady hand.

Click to expand...