- Joined
- Jan 5, 2009
- Messages
- 38
- Points
- 0
Hey everyone i am looking to make a laser for the first time.
I would like to know what it a good host for a first time builder.
I would like to use the Aixiz housing and a lavadrive or a rckstr driver. What is a good host that is about 8 inches or smaller, but not to small that i could barley work with. I am also wondering if i need a heat sink. I am kind of tight on money so if i need a heat sink i will make on out of washers. I would prefer if the host ran on 4 or less AAAs or AAs.
If there is a better one that runs on CR123A then that will be Ok. Thanks
I would like to know what it a good host for a first time builder.
I would like to use the Aixiz housing and a lavadrive or a rckstr driver. What is a good host that is about 8 inches or smaller, but not to small that i could barley work with. I am also wondering if i need a heat sink. I am kind of tight on money so if i need a heat sink i will make on out of washers. I would prefer if the host ran on 4 or less AAAs or AAs.
If there is a better one that runs on CR123A then that will be Ok. Thanks