Max Current??

• Dec 10, 2010

• #1

L

luckyduck41221

0

Joined

Oct 25, 2010

Messages

3

Points

0

I have recently built a burning laser with a 300 mw red laser diode. I am using a 100 ohm pot. How much current can the diode handle before it burns up? It is set quite low at the moment and I don't want to raise it very much until I know the threshold.

Thanks in advance

 

• Dec 10, 2010

• #2

Elektrotechniker

0

Joined

Nov 10, 2008

Messages

4,186

Points

63

I assume you are talking about a red LOC laser diode. If yes, the "safe" current of these diodes has been found to be 420 mA. Many have pushed them up to 500+ mA but the life of the diode is decreased. At 450 mA you will get something like 250+ mW.

 

• Dec 10, 2010

• #3

L

luckyduck41221

0

Joined

Oct 25, 2010

Messages

3

Points

0

I'm not sure if it's an LOC diode. This is the diode I am using.

650nm 300mw Burning Red Laser Diode USA Kipkay Suitable - eBay (item 280601753953 end time Dec-19-10 16:38:42 PST)

 

• Dec 10, 2010

• #4

A

anselm

0

Joined

Nov 22, 2010

Messages

2,448

Points

0

I guess it's too late now, but I'd never buy anything with "KipKay" in the
title or advertising.
Also, that diode is Closed Can, not Open Can.

 

• Dec 10, 2010

• #5

midias

0

Joined

Mar 14, 2010

Messages

631

Points

0

What driver are you using for what current?

The auction says Recommended current: 300-330mA I would start there and check for heat problems.

 

• Dec 10, 2010

• #6

L

luckyduck41221

0

Joined

Oct 25, 2010

Messages

3

Points

0

Thanks, I didn't even notice that was listed on the auction page.

 

• Dec 10, 2010

• #7

midias

0

Joined

Mar 14, 2010

Messages

631

Points

0

luckyduck41221 said:

Thanks, I didn't even notice that was listed on the auction page.

Click to expand...

You may be able to go higher but I would start with 300 and slowly twist a pot and check for heat before twisting more.