Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

Buy Site Supporter Role (remove some ads) | LPF Donations

Links below open in new window

FrozenGate by Avery

How do i install this switch?

nosebleedXD

nosebleedXD

0
Joined
Oct 16, 2008
Messages
378
Points
0





It seems you've copied and pasted the wrong URL for the switch, you've pasted your shopping cart link.

Anyways, switches are very simple devices, they consist of nothing more than a wire which is connected when you push the switch. There should only be two wires coming out of the switch, one of them should go to the - terminal of your battery, the other should go to the - terminal of your driver.
 
The middle pin of that switch and either of the side pins will be disconnected by default, then connected when the switch is pressed.

Solder the middle pin of the switch to your battery, solder either of the side pins to your driver. The driver will only get voltage when the switch is pressed.

Good luck! :)
 
well i was thinking of getting that and how would i do it if i got that

but i found something similar i took apart and used that instead

its similar to that switch but then it only has two pins, a positive and a negative
 
well then, solder one side of the switch to the battery, the other to your driver.

think about how a switch could possibly work, see if you can grasp the concept, it's not difficult. it's just two metal pieces that aren't touching, then when you press the switch they touch, completing the circuit.
 
oh ..... kk i got it to work thanks

so basically this is what i was suppose to do right? and i did

i connected the positive side of the battery to the driver directly

then i connected the negative from the battery to one side of the switch

and then the other pin of the switch, i attached it to the negative side of the driver

=] now it works thanks
 
You must log in or register to reply here.


Back
Top