- Joined
- Jun 26, 2012
- Messages
- 788
- Points
- 28
Hey all, I'm pretty proud to say that I've finally built a laser, after months of reading and searching I've finally made a something i'm proud of.
Diode: $7.50 from Odicforce.
Modules and module press: $25 Came in a pack of three modules + the press tool from DTR.
Driver: $10 Shipped from Blord set at 460mAh.
Batteries: $17 Came with 2 16340 Batteries + a charger.
I still don't know the output power of it. Is anyone able to lend me they're LPM(Preferably in Australia)? i'm happy to pay express postage both directions, I have another green module sitting in the draw which will be going into a host once it arrives + I have all the parts for another LPC-826 Build when they arrive. So they will all need LPMing because I want accurate outputs on the danger stickers.
Thanks for reading!
What did it cost?
Host: $50 shipped from Jayrob.Diode: $7.50 from Odicforce.
Modules and module press: $25 Came in a pack of three modules + the press tool from DTR.
Driver: $10 Shipped from Blord set at 460mAh.
Batteries: $17 Came with 2 16340 Batteries + a charger.
Some Photos:
Things I wanna do:
- I wanna get a warning sticker made, Which i'll be doing in a couple of days.
I still don't know the output power of it. Is anyone able to lend me they're LPM(Preferably in Australia)? i'm happy to pay express postage both directions, I have another green module sitting in the draw which will be going into a host once it arrives + I have all the parts for another LPC-826 Build when they arrive. So they will all need LPMing because I want accurate outputs on the danger stickers.
Thanks for reading!
Last edited:
and usually for the lpm you do it the opposite way... you send them your laser and they lmp it for you. Also this grand total could have been a lot cheaper. The DIY c6 is on DX for $10 and you can get a heat sink here for $10 here too. I'm not saying anything is wrong with buying it from jayrob and I don't want him to lose business. But good job on your first build!
