white laser on metacafe!

when will somebody do a diy project for one of these? and show us how you make them?

There is a tutorial for the optics assembly here
http://www.laserpointerforums.com/forums/YaBB.pl?num=1229256424
There is a tutorial on making a spiro projector here
http://www.laserpointerforums.com/forums/YaBB.pl?num=1186862602

If you follow both of those and amalgamate the results in a project box you will have a very desirable laser.

There is little point in me detailing the host body as, I would guess, very few laser builders have the following workshop equipment available to them.
Lathe
Pillar drill
Vertical mill
power hacksaw

All of which were heavily used in the build.

Regards rog8811

Wait, you have to get 20.000 views in the US and be over 4 stars? I thought it was 3 stars......Metacafe is getting cheap :-/

I thought it was 3 stars......Metacafe is getting cheap

Click to expand...

You are quite right :...I am hanging by a thread at the moment, just above 3 and 14k short

Regards rog8811

rog you got a rough cost of what one of these is to make in total

rog you got a rough cost of what one of these is to make in total

Click to expand...

I have been asked a few times about building costs....
The following just covers what I had to buy, most of the materials were in stock (sounds very grand ) This does not take into account the hours of design and build work......

OPTICAL ASSEMBLY

Red LD                 $20.00

Blu ray LD             $12.00

Green module        $15.00  

PS3 sled                                  Had some knocking around  

Rkcstr drive X 2      $36.00         Or build your own for cents

Aixiz modules X 2   $7.00

Brass barstock       $1.00  

                                                                                       $91.00

SWITCH GEAR

6 way switch          $6.00

on/off/on switch      $3.00

Motor X2                $5.00  

100ohm pot           $2.00

                                                                                       $16.00  

MATERIALS  

2 1/2" aluminium     $18.00

stainless tube        $20.00

                                               Rest of materials knocking around  

                                                                                       

                                                                                       $38.00

     

                                                             Grand total         $145.00

From this thread  http://www.laserpointerforums.com/forums/YaBB.pl?num=1230589033

Regards rog8811  

[edit]Could some of you go onto my video and post a comment so that I can get it back on a front page pleeeeaaaasssseeee!!!!!!
I am on page 2 of most discussed this week Taa[/edit]

andy_con said:

rog you got a rough cost of what one of these is to make in total

Click to expand...

I would imagine that you need more time and patience rather than money


I don't think anyone has given you less than 5 stars rog, it's just that metacafe counts non rating visitors as a 0 or something :-/

I don't think anyone has given you less than 5 stars rog, it's just that metacafe counts non rating visitors as a 0 or something

Click to expand...

I am not sure how it works...other than when I rated a video, for the first time, I did a stupid thing and just clicked randomly on the stars thinking it would open a dialogue box....it didn't I clicked on the 1 star and that is what I rated the video at

Regards rog8811