Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Tiny spiro.....

Joined
Jul 24, 2007
Messages
2,749
Points
0
As I have been asked elsewhere about the circuit in this I will post a schematic.

The problem to be solved was this:

SenKat red needs a regulated supply of ~3v
Motors need a supply of ~1.5v
Battery to be used 9V

The answer?
Use an LM317 driver and use the motors in parallel with a resistor to set the current for the LD (they run from the 1.25v ref voltage) ;)
A word of warning though, when you are playing about trying to set the motors up do not allow the wire to the motor to touch each other....it allows 1A to get to the diode..... ::)

Regards rog8811
 

Attachments

  • Circuit03.jpg
    Circuit03.jpg
    34.5 KB · Views: 94





Joined
Jul 24, 2007
Messages
2,749
Points
0
how did you engrave the zippo
There is an ebay seller who will engrave whatever you want on the lighter, it isn't a zippo but at £7.50 engraved and delivered not a bad deal.

Regards rog8811
 




Top