Gryphon
0
- Joined
- May 4, 2009
- Messages
- 2,237
- Points
- 83
I just finished a little 2 axis laser etcher of sorts. It uses sleds from dvd drives and is controlled by an Arduino. I am by no means a good programmer so the code that controls it is more than likely horribily ineffecient, but i am happy that it works. So far ive made three different designs for it to draw, the FaceBook logo, the YouTube logo and the Aperture Science logo from the Portal games.
Diode: a140
Driver: LM317T ~1.25A
Lens: Aixiz 405nm AR
The Arduino is a Micro and the stepper motor drivers are EasyDrivers from sparkfun.
Diode: a140
Driver: LM317T ~1.25A
Lens: Aixiz 405nm AR
The Arduino is a Micro and the stepper motor drivers are EasyDrivers from sparkfun.
Last edited: