- Joined
- Sep 28, 2007
- Messages
- 1,520
- Points
- 0
I have a 50mW module from DragonLasers that I was originally intending to use for a DIY laser show but thats been set back a few months now.
Its in rather small heatsink, like the one aixiz has on their website for their greens.
http://mfgcn.com/_wsn/page3.html
Thing is as its not being used for its original intention and its way over spec, lighting a match from 2 meters away I was thinking of focusing it a little better than what it is now. At about 4 meters away the dot is already 1.5cm big.
Do I just turn the bit on the front of the heatsink using the two pin holes either side of the aperature?
Its in rather small heatsink, like the one aixiz has on their website for their greens.
http://mfgcn.com/_wsn/page3.html
Thing is as its not being used for its original intention and its way over spec, lighting a match from 2 meters away I was thinking of focusing it a little better than what it is now. At about 4 meters away the dot is already 1.5cm big.
Do I just turn the bit on the front of the heatsink using the two pin holes either side of the aperature?