Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Testing Current Load

Joined
Oct 24, 2008
Messages
1,057
Points
48
Ok so I'm implementing home made drivers and want a means to test for voltage and current across a laser diode emulating load. I have put together a quick and easy little circuit for blu-ray and red diode leads.

The diodes are 1N4001 rectifier diodes. To those who have experience with laser emulating loads, is this a good setup? How exactly does a series of standard diodes and a resistor emulate a Laser diode?

When the switch is closed it will bypass three diodes for testing red diodes. Otherwise it's for blu-ray diodes.

What do ya think?

-Tony
 

Attachments

  • Dummy_load.JPG
    Dummy_load.JPG
    11.6 KB · Views: 90





Joined
Oct 14, 2008
Messages
233
Points
0
I haven't looked at the I-V characteristics of the BR or red diodes, but you should take a look at the test board from StoneTek's website.  The I-V characteristics of the 1N4001 and the diodes he uses are different, but it shouldn't matter in the long run.  I would use 6 diodes for the BR and 4 diodes for the red if I was you (200mA ~ 0.8V with the 1N4001), and minimize the resistance of the test resistor to avoid putting improper emphasis on the resistor and to reduce the power output P = I^2 R.

Just make sure you're using the test load for a constant-current driver.  Besides the fact that constant voltage dividers aren't good for diodes, you're using the test load to measure current, and to do a very rough approximation of the voltage.

Edit:  I completely overlooked the pic.  It looks good, other than you should bridge only two diodes, not three.

Edit2: Do NOT flip the switch while the circuit is on/there are attached charged capacitors.
 

rkcstr

0
Joined
Dec 1, 2007
Messages
1,368
Points
0
Yeah, the circuit essentially the same (without one of the non-essential parts) as my Test Load (that Stonetek sells).

Most people, for standard 1N400x diodes, use 4 for red to get appx. 3V on load, but I use 3 because of the diodes I use, at the currents typical for red (and the added resistor voltage), will be around 3V. While 6 of them will be more in-line with a blu-ray diode at their usual currents. They obviously won't be exact, but good enough.
 




Top