- Joined
- Dec 28, 2011
- Messages
- 31
- Points
- 0
Greetings,
I have bought a laser module already wired up to an Aixiz module, but I want to press this into a aluminum heat sink block, which I have read would work well with a 15/32 drilled hole (~11.9mm). Can the module be pressed in with the laser still attached, assuming the front lens holder is screwed it?
Cheers,
Dean
I have bought a laser module already wired up to an Aixiz module, but I want to press this into a aluminum heat sink block, which I have read would work well with a 15/32 drilled hole (~11.9mm). Can the module be pressed in with the laser still attached, assuming the front lens holder is screwed it?
Cheers,
Dean