- Joined
- Jan 20, 2011
- Messages
- 5
- Points
- 0
Hello all,
Today, I received CW20 scanner, amp board and DMX control board that I ordered from laserpic . I powered up the board , DMX controller board as stated in the manual. I have turned on switch no 10 in the DMX board. I am trying to move or control the scanners manually as described in the manual. But nothing happens. I dont understand certain things in the manual too... Especially
"this mean is 1 x 2 + 1 x 16=18, the same you must select DMXchannel 18 for you Start channel, DMXchannel 42 for your End channel." . Can anyone please guide me or give some ideas to control the scanners.
Thanks again.
Today, I received CW20 scanner, amp board and DMX control board that I ordered from laserpic . I powered up the board , DMX controller board as stated in the manual. I have turned on switch no 10 in the DMX board. I am trying to move or control the scanners manually as described in the manual. But nothing happens. I dont understand certain things in the manual too... Especially
"this mean is 1 x 2 + 1 x 16=18, the same you must select DMXchannel 18 for you Start channel, DMXchannel 42 for your End channel." . Can anyone please guide me or give some ideas to control the scanners.
Thanks again.