Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

Laser not getting full potential.

Joined
Mar 5, 2012
Messages
161
Points
18
Im using a Mitsubishi ML101U29 diode with a adjustable x-driver.

This is not in a host except built on a bread board and powered by a 12v wall power supply.

Everything is soldered for the best contact.

Driver has been tested with a load and is putting out .200ma which is what i wanted it set at.

12v going into the driver, and 12v coming out of the driver when no diode connected.

BEFORE when I connected the diode, it was putting out about 7v but now its only a little over 2v.

Did I short my driver or whats going on?
The laser diode is coming on but not to its full potential.
 





Joined
Mar 5, 2012
Messages
161
Points
18




Top