- Joined
- Nov 30, 2011
- Messages
- 7
- Points
- 0
Hi all,
I am new to this forum, I was looking for some information regarding a new pointer device I am designing and stumbled across this forum.
I while ago I built a simple laser using an off the shelf 635 module
the switch on this recently broke. I use it for machine alignment purposes.
This inspired me to improve on my original design.
The biggest improvement I could make would be to make the red dot smaller and brighter. I cannot work out the best ways of doing this.
Can some one offer me some solutions to help me get started.
the current dot is probably around 2-3 mm diameter if I could get it to about 1mm and increase the focus the pointer would be great.
Also the laser point needs to be not burn the eyes visible
Thanks, Andy.
I am new to this forum, I was looking for some information regarding a new pointer device I am designing and stumbled across this forum.
I while ago I built a simple laser using an off the shelf 635 module
the switch on this recently broke. I use it for machine alignment purposes.
This inspired me to improve on my original design.
The biggest improvement I could make would be to make the red dot smaller and brighter. I cannot work out the best ways of doing this.
Can some one offer me some solutions to help me get started.
the current dot is probably around 2-3 mm diameter if I could get it to about 1mm and increase the focus the pointer would be great.
Also the laser point needs to be not burn the eyes visible
Thanks, Andy.