NKO29
0
- Joined
- Jun 6, 2013
- Messages
- 861
- Points
- 28
hey, i am new here so if i get some things wrong dont judge me
anyways, i bought a 200mW laser module off DX.com and i mounted it in a housing that was powered by 2 AAA batteries. the laser worked fine, but i wanted to up the power because it wasnt set at 200mW. i took it out of the housing and tried turning the Potentiometer but it broke in half :O i can solder very well, but i have no idea on how many ohms the pot was, so i was wondering if i can just solder a replacement pot on, which would be relatively cheap, or do i have to buy a new driver? and if i had to buy a new driver what one should i get that would be compatible with the laser module that i bought?
(DX.COM 200mW green 3V)
Thanks for reading :beer:
anyways, i bought a 200mW laser module off DX.com and i mounted it in a housing that was powered by 2 AAA batteries. the laser worked fine, but i wanted to up the power because it wasnt set at 200mW. i took it out of the housing and tried turning the Potentiometer but it broke in half :O i can solder very well, but i have no idea on how many ohms the pot was, so i was wondering if i can just solder a replacement pot on, which would be relatively cheap, or do i have to buy a new driver? and if i had to buy a new driver what one should i get that would be compatible with the laser module that i bought?
(DX.COM 200mW green 3V)
Thanks for reading :beer: