DIY 405nm pointer- NOW WITH BEAM SHOTS pg.3

Milos · Feb 5, 2008

Re: My first DIY Blueray portable pointer.

.

Milos · Feb 5, 2008

Re: My first DIY Blueray portable pointer.

.

Milos · Feb 5, 2008

Re: My first DIY Blueray portable pointer.

.

Milos · Feb 5, 2008

Re: My first DIY Blueray portable pointer.

.

Milos · Feb 5, 2008

Re: My first DIY Blueray portable pointer.

.

Milos · Feb 5, 2008

Re: My first DIY Blueray portable pointer.

.

Milos · Feb 5, 2008

Re: My first DIY Blueray portable pointer.

and the guilty one..

Milos · Feb 5, 2008

Re: My first DIY Blueray portable pointer.

.

Milos · Feb 5, 2008

hmm, more that I think about it, more it puzzles me. Does anyone know why we always get this fluloresenting colors to be just like DPSS available colors (532nm and 594nm) and not some other colors. Is it just coincidence?

jayrob · Feb 5, 2008

Good job Milos! Nice pictures too. I am so ready for a blu-ray...
Jay

Milos · Feb 11, 2008

jayrob said:
Good job Milos! Nice pictures too. I am so ready for a blu-ray...
Jay

thanks jayrob,
I want to figure out better heat sink and fit open can phasor diode in this new case. 300mW+ of RED is getting to my head now :

:

jayrob · Feb 11, 2008

Milos, for those 300mW BURNERS, we like the MXDL host for the open can. I'm selling the heatsinks now:
http://www.laserpointerforums.com/forums/YaBB.pl?num=1202452073/0
They are custom fit for the MXDL...
Jay

bcroft · Feb 11, 2008

milos, i saw what pot you used i have a ton of those little ones and dont know a thing about them, how do you know if it will work in the driver?

Milos · Feb 11, 2008

jayrob said:
Milos, for those 300mW BURNERS, we like the MXDL host for the open can. I'm selling the heatsinks now:
http://www.laserpointerforums.com/forums/YaBB.pl?num=1202452073/0
They are custom fit for the MXDL...
Jay

yes, I saw this thread. Great work guys!
I will be going different rout though trying to keep cost below $50 for everything, so I will be using stuff I have around. Thanks though.

milos, i saw what pot you used i have a ton of those little ones and dont know a thing about them, how do you know if it will work in the driver?

This is a regular single turn pot. All you need to do is test your pots with ohm meter on your multimeter. Join one side pin to the middle and connect one probe to it. The other probe connect to the remaining pin. If you rotate the pot, it will show you min and max resistance on the multimeter.

bcroft · Feb 13, 2008

awesome! thank you

DIY 405nm pointer- NOW WITH BEAM SHOTS pg.3

0

Attachments

0

Attachments

0

Attachments

0

Attachments

0

Attachments

0

Attachments

0

Attachments

0

Attachments

0

0

0

0

0

0

0