LPF Donation via Stripe | LPF Donation - Other Methods
Links below open in new window
ArcticMyst Security by Avery
4 LPC in parallel
- Thread starter mpmsfilho
- Start date
3zuli
0
- Joined
- May 30, 2009
- Messages
- 810
- Points
- 28
by using 4 drivers set to 240mA, one driver for each doide? :thinking: 
- Joined
- Sep 12, 2007
- Messages
- 9,399
- Points
- 113
Or have them in series, and supply the driver with 12V
Parallel is not recommended, because each diode will draw a different current.
Parallel is not recommended, because each diode will draw a different current.
jaycey
0
- Joined
- Apr 10, 2009
- Messages
- 480
- Points
- 18
Then you want a Flexmod driver available (soon?) from Dr Lava
Wired in series with some resistors.
Wired in series with some resistors.
- Joined
- Jan 12, 2008
- Messages
- 3,290
- Points
- 83
I'm not sure why you would need the resistors if you connect the diodes in series... Each laser module must be electrically isolated from the heatsink and each other to prevent them from shorting out.
- Joined
- Oct 26, 2007
- Messages
- 5,438
- Points
- 83
Don't use them in parallel, as you can't guarantee that each diode will receive an even amount of current. Even if it worked properly, the AMC7135 can only sink 350mA, so divided four ways would be only 88mA each.
Just buy one of Dr Lava's Microboost drivers, set it for 250mA, and connect it to the four laser diodes in series.
Just buy one of Dr Lava's Microboost drivers, set it for 250mA, and connect it to the four laser diodes in series.
aXit
0
- Joined
- Sep 15, 2009
- Messages
- 206
- Points
- 0
While that would work, FML raises a valid point.
It's easy enough to distribute current equally through the parallel diodes. A resistor in series with each diode.
- Joined
- Oct 24, 2008
- Messages
- 1,057
- Points
- 48
While that would work, FML raises a valid point.
It's easy enough to distribute current equally through the parallel diodes. A resistor in series with each diode.
That would not distribute the current evenly. Only voltage will be evenly supplied across them.
-Tony
aXit
0
- Joined
- Sep 15, 2009
- Messages
- 206
- Points
- 0
No, it will distribute current evenly. While it's not perfect, it's pretty close.
All the diodes are the same, so we can say that the forward voltages of each one are within a small margin.
If V+ is a constant current supply, and the resistors are low value, say... 10ohms, then the current will be split evenly between the laser diodes.
The resistors act as a balancing device, in that if more current started to go through one diode, the resistor in series with it would have a higher voltage drop, encouraging more current to travel through the lower voltage circuits.
Like I said, it's not perfect, and it doesn't work with anything except identical diodes, but it does work.
