Welcome to Laser Pointer Forums - discuss green laser pointers, blue laser pointers, and all types of lasers

LPF Donation via Stripe | LPF Donation - Other Methods

Links below open in new window

ArcticMyst Security by Avery

7.3 Watt cutting metal

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
Those IR thermometers aren't very accurate on shiny metal surfaces though, nor on pools of liquid metals. By the time you get over 1000 C or so you'll probably be able to tell rough temperature by the glow color you see.

Magnesium should be interesting as it's auto-ignition temperature can be quite low depeding on form factor. Something like magnesium ribbon or fine shavings can be set on fire around 500 C. I suppose it's possible to set a thin sheet of magnesium on fire when trying to laser-cut it in air. Probably a nicely satisfying thing to watch, but be careful as those fires are hard to put out once blazing.
 





Joined
Jan 14, 2009
Messages
1,452
Points
83
I remember lighting magnesium ribbon strips with the 60W co2 laser I had , did take a good 20 seconds or so but that was probably due to the poor absorption of the 10.6um light
 

Benm

0
Joined
Aug 16, 2007
Messages
7,896
Points
113
Possibly - it's also quite reflective to visible light, though ribbon will slowly tarnish a bit which normally makes it more difficult to ignite with a flame, but perhaps easier with a (visible) laser.
 




Top