bobo99
0
- Joined
- May 18, 2011
- Messages
- 128
- Points
- 18
Hey guys,
Have been around here for a few months and , well... love lasers.
Bought a survival laser, hopped on a group buy the other month and now would like to give a shot at a custom build.
I would like to build a custom 405 or 445 build, 400-500mW.
I have a host in mind that is built to hold 3 AAA's. (very tiny) Its my understanding that a driver could be run at this voltage.
Since I dont have a lpm, and don't plan on getting one, I'd like to have someone do the calibration of the driver for me. I would handle the creation of a heat-sink.
What I would be looking for would be (preferably all from the same person):
1) blue or violet diode
2) Small, very small driver calibrated to give me the power output @ 4.5V
3) Aixiz mounting - with lens
4) Advice - Would 3xAAA give enough current, or should I try and modify the host. It could handle two CR123A, but I'd like to keep it simple stupid for the first build.
Shipped to Canada.
Thanks!
Have been around here for a few months and , well... love lasers.
Bought a survival laser, hopped on a group buy the other month and now would like to give a shot at a custom build.
I would like to build a custom 405 or 445 build, 400-500mW.
I have a host in mind that is built to hold 3 AAA's. (very tiny) Its my understanding that a driver could be run at this voltage.
Since I dont have a lpm, and don't plan on getting one, I'd like to have someone do the calibration of the driver for me. I would handle the creation of a heat-sink.
What I would be looking for would be (preferably all from the same person):
1) blue or violet diode
2) Small, very small driver calibrated to give me the power output @ 4.5V
3) Aixiz mounting - with lens
4) Advice - Would 3xAAA give enough current, or should I try and modify the host. It could handle two CR123A, but I'd like to keep it simple stupid for the first build.
Shipped to Canada.
Thanks!
Last edited:
