WTB: flexdrive or driver for 400mA @ 1 3.7 battery

scumbagatheist · Feb 22, 2013

Hi all!

I've ordered one of DTR's 300mw, 650nm diodes and am looking for a driver (flex or buck boost) to drive this diode @ 350-400mA. I lack any sophisticated tuning equipment, etc, so I would like it preset if possible.

Here is the build that this driver/diode are going into.

Thank you for your time.

DTR · Feb 22, 2013

You could get one of these.
Mohgasm Linear Driver - $4.99 : Mohgasm LLC, Have you experienced one lately?

And use the 3XAAA holder with two 10440's and a AAA spacer. You could probably get the batteries and the driver for less than the cost of a Flexdrive. You would give up some capacity but still you should be able to get almost an hour of runtime before recharging. Moh has a 378mA option.:beer:

scumbagatheist · Feb 22, 2013

Thanks DTR! No, I haven't experienced one of Mohgasm's driver. I have seen so many builds featuring them.

Would you mind taking the time to tell me and the other members why these drivers seem to be such good performance? It'd also be a good way to promote a felllow member, rather than a faceless corporation.

ENX · Feb 22, 2013

You could buy a Flex Drive V5 from Flaminpyro. If you bridge the 2 resisters as shown in the specs http://hacylon.case.edu/ebay/laser_diode/MicroFlexDrive_V5_manual.pdf, you would be in the 100ma - 412ma range. If you don't have a volt meter, you could probably guesstimate where the max output is.

Hope this helps

PS: if you haven't slready, you should invest in a good voltmeter and variable test load. All can be under $30 and very useful for this hobby.

Zeebit · Feb 22, 2013

ENX said:
you don't have a bolt meter, you could probably guesstimate where the max output is.

VOLT meter

Moistenator · Feb 23, 2013

scumbagatheist said:
Thanks DTR! No, I haven't experienced one of Mohgasm's driver. I have seen so many builds featuring them.

Would you mind taking the time to tell me and the other members why these drivers seem to be such good performance? It'd also be a good way to promote a felllow member, rather than a faceless corporation.

There cheap.. If you using a build that uses 2 batteries you may as well use one because of how cheap it is.. You might want to heatsink the driver but.. These do get hot.

WTB: flexdrive or driver for 400mA @ 1 3.7 battery

scumbagatheist

1

DTR

0

scumbagatheist

1

ENX

0

Zeebit

0

Moistenator

0

Online statistics

Forum statistics

Share this page