WackBag
0
- Joined
- Aug 26, 2008
- Messages
- 387
- Points
- 18
For Sale is an AixiZ 532nm 100mW+ lab style laser affixed (hot glued) in an AC enclosure. The enclosure holds the green labby and its power supply. The 9 volt battery is attached to a small fan, it could be wired to the power supply permanently as well. I also purchased many new parts in order to put together a Spirograph. Included in the sale is the following:
- AC powered enclosure with power cord
- AixiZ 532nm green lab style laser (measured constant 107mW's using a LaserBee I meter) can be adjusted using the pot on the power supply
- 5x one inch round mirrors
- 3x 100 ohm potentiometers linear taper
- 2x DC Mabuchi motors
- 1x Peltier TEC 5-12v thermoelectric cooler
- 1x on/off lighted rocker switch
- 3x 1/2" diameter knobs (fit potentiometers)
- 1x knob for 1/8" shaft
- 1x AC to DC 5v/8A, 3.3v/4A, 2.5v/2A power supply
There are several tutorials on LPF to help you finish this project. I am asking $100.00 plus $15.00 for USPS 1st class shipping in the US. International shipping request need to PM me for a quote. There is plenty of room in the enclosure to place the mirrors/motors. The enclosure has an easy sliding removable cover allowing easy access to the inside. This kit is probably not complete, meaning that you may need to purchase some other small parts for completion. Thanks and let me know if you have any questions...
Enclosure with all parts for sale
Closeup of separate power supply for the motors
Closeup of inside
Closeup of individual parts
Back of enclosure (used SCSI hard drive enclosure)
- AC powered enclosure with power cord
- AixiZ 532nm green lab style laser (measured constant 107mW's using a LaserBee I meter) can be adjusted using the pot on the power supply
- 5x one inch round mirrors
- 3x 100 ohm potentiometers linear taper
- 2x DC Mabuchi motors
- 1x Peltier TEC 5-12v thermoelectric cooler
- 1x on/off lighted rocker switch
- 3x 1/2" diameter knobs (fit potentiometers)
- 1x knob for 1/8" shaft
- 1x AC to DC 5v/8A, 3.3v/4A, 2.5v/2A power supply
There are several tutorials on LPF to help you finish this project. I am asking $100.00 plus $15.00 for USPS 1st class shipping in the US. International shipping request need to PM me for a quote. There is plenty of room in the enclosure to place the mirrors/motors. The enclosure has an easy sliding removable cover allowing easy access to the inside. This kit is probably not complete, meaning that you may need to purchase some other small parts for completion. Thanks and let me know if you have any questions...
Enclosure with all parts for sale
Closeup of separate power supply for the motors
Closeup of inside
Closeup of individual parts
Back of enclosure (used SCSI hard drive enclosure)