- Joined
- Feb 18, 2012
- Messages
- 148
- Points
- 18
SOLD
The “Bushwhacker”
Features:
• 445nm M-140 diode
• 1.8A Mogasm round driver. The resistors are heatsinked with small blocks of copper that make the tops even with the top of the IC. Then the whole thing is heatsinked with 2 layers of 1/8” thick copper, one fit tightly inside the pill and the other fit into the top of the pill and in solid contact with both the pill and with the main heatsink. All components are bonded with arctic silver (real silver not the alumina).
• Massive copper heatsink! Just under 1.5” in diameter and 1.5” long. The diode is pressed into a copper module which is pressed into the heatsink (not pressed up against one side by a set screw) for maximum contact
• 405-G-2 lens with ¾” focus adapter
• 2x new AW 700mAh IMR 18350 batteries (included)
• Custom paracord wrapping
This laser was designed to have an incredible duty cycle, and I put a lot of very meticulous work into achieving that.
In this case, the limiting factor for continuous runtime is battery capacity, NOT heat; therefore there is NO DUTY CYCLE necessary.
I have no LPM data for this laser, but with an M-140 driven at 1.8A and running cool with a G-2 lens, it should be around 2W. I am very willing to use a middleman to measure the output before a sale is finalized.
You must provide proof that you own eye protection for 445nm in order to purchse this laser. If you don't have eye protection, Uvex SCT-Orange glasses can be included
Size comparison with a C6
The “Bushwhacker”
Features:
• 445nm M-140 diode
• 1.8A Mogasm round driver. The resistors are heatsinked with small blocks of copper that make the tops even with the top of the IC. Then the whole thing is heatsinked with 2 layers of 1/8” thick copper, one fit tightly inside the pill and the other fit into the top of the pill and in solid contact with both the pill and with the main heatsink. All components are bonded with arctic silver (real silver not the alumina).
• Massive copper heatsink! Just under 1.5” in diameter and 1.5” long. The diode is pressed into a copper module which is pressed into the heatsink (not pressed up against one side by a set screw) for maximum contact
• 405-G-2 lens with ¾” focus adapter
• 2x new AW 700mAh IMR 18350 batteries (included)
• Custom paracord wrapping
This laser was designed to have an incredible duty cycle, and I put a lot of very meticulous work into achieving that.
In this case, the limiting factor for continuous runtime is battery capacity, NOT heat; therefore there is NO DUTY CYCLE necessary.
I have no LPM data for this laser, but with an M-140 driven at 1.8A and running cool with a G-2 lens, it should be around 2W. I am very willing to use a middleman to measure the output before a sale is finalized.
You must provide proof that you own eye protection for 445nm in order to purchse this laser. If you don't have eye protection, Uvex SCT-Orange glasses can be included
Size comparison with a C6
Last edited:
