- Joined
- Aug 30, 2008
- Messages
- 6,891
- Points
- 83
SOLD SOLD
I've got two of these available. These are the stainless steel ultrafire cree c3 hosts. They take 1x14500 (AA sized) battery.
I made a couple modifications to the host.
-
I stripped the stock driver
Drill the top of the pill to open it up for the flex/microboost drive.
I also replaces the GITD tailcap with a black tailcap.
I felt the black looked better, but i will be including the GITD tail cap in case you want to swap them out. You can use the spare as a lens cover.....
this kit is intended for a microboost or flex drive driven by 1x14500 battery.
if your intending on building a 445nm laser, you'll only achieve around 700mW, depending on the battery you have...
kit includes:
modified host (stripped driver,drilled pill,black rubber tailcap)
Custom aluminum heat sink with 1 set screw
GITD stock tailcap cover
hex key
FlaminPyro silicone wires
Asking $30 shipped. I have 2 of these available.
I've got two of these available. These are the stainless steel ultrafire cree c3 hosts. They take 1x14500 (AA sized) battery.
I made a couple modifications to the host.
-
I stripped the stock driver
Drill the top of the pill to open it up for the flex/microboost drive.
I also replaces the GITD tailcap with a black tailcap.
I felt the black looked better, but i will be including the GITD tail cap in case you want to swap them out. You can use the spare as a lens cover.....
this kit is intended for a microboost or flex drive driven by 1x14500 battery.
if your intending on building a 445nm laser, you'll only achieve around 700mW, depending on the battery you have...
kit includes:
modified host (stripped driver,drilled pill,black rubber tailcap)
Custom aluminum heat sink with 1 set screw
GITD stock tailcap cover
hex key
FlaminPyro silicone wires
Asking $30 shipped. I have 2 of these available.
Last edited: