Jufran88
0
- Joined
- Feb 9, 2011
- Messages
- 578
- Points
- 0
Hey guys, I'm trying to clear out some of my stuff to make room for future projects.
I am also contributing $1 to LPF for every driver sold until I am sold out. I know it's not a lot, but it still helps. :yh:
Linear drivers
LM1084 based linear driver: $8 shipped CONUS! (INTL available at extra cost)
I am limited to what resistors I have on hand which limits current setting to 50mA to 2A. Just let me know what current you want!
Also, you will need to supply your own heat sinks if over 1A!
LM1117 based linear driver: $6 shipped CONUS! (INTL available at extra cost)
Size comparison
DIY LPM KITS
TEC based
Screw type connectors not supplied in kit
Lenses
Acrylic AR coated lenses: $1.25 + $1.69 shipping CONUS! (INTL available at extra cost)
Heat sinks
C6 aluminum heat sinks: $5 + $1.69 shipping CONUS (INTL available at extra cost)
That's it for now guys, thanks for looking! :beer:
I am also contributing $1 to LPF for every driver sold until I am sold out. I know it's not a lot, but it still helps. :yh:
Linear drivers
LM1084 based linear driver: $8 shipped CONUS! (INTL available at extra cost)
- Low drop out (~0.8V)
- Input voltage: 2.6V to 10V (Limited by input capacitor)
- Output voltage: 1.2V to 10V (Limited by output capacitor)
- Output current: 50mA to 2000mA (5A max)
- 2 x lithium ion batteries recommended
- Outputs over 1A heat sink is a must! Both IC and resistors!
- Dimensions (11mm x 17mm)
- Continuous ground
I am limited to what resistors I have on hand which limits current setting to 50mA to 2A. Just let me know what current you want!
Also, you will need to supply your own heat sinks if over 1A!
LM1117 based linear driver: $6 shipped CONUS! (INTL available at extra cost)
- Input voltage: 2.6V to 10V Max (Limited by input capacitor)
- Output voltage: 1.25V to 10V (Limited by output capacitor)
- Output current: 108mA to 800mA (950mA max)
- 2 x lithium ion batteries recommended
- Dimensions (7.8mm x 10.6mm)
- Continuous ground
Size comparison
DIY LPM KITS
TEC based
- DIY kit: $8 shipped CONUS (INTL available at extra cost)
- TEC, heat sink, and voltmeter not supplied
- You will need your own way to calibrate this LPM once completed
Screw type connectors not supplied in kit
Lenses
Acrylic AR coated lenses: $1.25 + $1.69 shipping CONUS! (INTL available at extra cost)
- 405nm - 600nm
- M9 x 0.5 frame
- 10% increased output over standard acrylic lens
- 2% increased output over 3-element glass lens
- Recommended for under 500mW to prevent melting due to heat
Heat sinks
C6 aluminum heat sinks: $5 + $1.69 shipping CONUS (INTL available at extra cost)
- Allen set screw included
- Allen key not included (1.5mm)
- Front can be polished at no extra charge just let me know!
That's it for now guys, thanks for looking! :beer:
Last edited:
