- Joined
- Jun 30, 2009
- Messages
- 212
- Points
- 0
Finally I have what I think is the last revision of the heat sink. As I had posted I was only making these for my project, but since I got several PM’s asking if I would sell these I figured I would make a couple more to see if they sell. Thanks to fellow forum members with their very helpful suggestions, I have made the modification they recommended. The sink is 1¼” long so it completely incases the Aixiz Module, the hole has been reduced so the module is a very tight fit but can still be installed with your fingers. I have drilled and tapped a 6-32 hole and installed a set screw in the center of the sink with 2 pilot holes that can be drilled out and tapped for mounting studs of your choosing. Again I tested this for 30 minutes with a 405 Blu-Ray diode using the Jayrob 405-G-1 lens and found it to be just warm to the touch. I am selling these for $20 plus $4.95 Pri-mail for shipping if anyone is interested, just PM me. I have 7 completed now and will make more when I run out. Thanks again for all the help, my project works great with the HS’s.
Last edited:
