Arayan
0
- Joined
- Oct 26, 2009
- Messages
- 1,746
- Points
- 48
I have one used PSU for 40W CO2 laser which is not very useful to me because it works with 110 V!
Since I'm looking for a red laser pointer, then I ask, is anyone is interested in exchanging one red pointer (200-300 mW) with the PSU
The only thing I ask is to pay shipping costs because the PSU is much heavier than a pointer :angel:
Technical Parameters
1.Input voltage: AC110V
2.Maximum output voltage: DC 30KV.
3.Maximum output current: DC 20mA.
4.Isolation Withstand voltage: Input-output, input-enclosure: AC2000V-10mA-60s; negative pole of output connected to enclosure.
5. Protection: with well-grounded enclosure, output circuit of power supply can be open for short time (but arc between positive pole and enclosure should be avoided).
6.Response time (from time of input being available to the output current being up to nominal value): ≤1ms.
7.TTL voltage level control: effective voltage level can be high or low through setting.
8.Protection switch: for detection of cooling water, to protect laser device; or activate with enclosure is opened.
9. Laser power adjustment: (1) by adjusting the output current of power supply through resistor; (2) through PWM control (magnitude being TTL voltage level).
10. Environmental requirements: temperature (-10~ 40℃), relative humidity ≤85%.
Since I'm looking for a red laser pointer, then I ask, is anyone is interested in exchanging one red pointer (200-300 mW) with the PSU
The only thing I ask is to pay shipping costs because the PSU is much heavier than a pointer :angel:
Technical Parameters
1.Input voltage: AC110V
2.Maximum output voltage: DC 30KV.
3.Maximum output current: DC 20mA.
4.Isolation Withstand voltage: Input-output, input-enclosure: AC2000V-10mA-60s; negative pole of output connected to enclosure.
5. Protection: with well-grounded enclosure, output circuit of power supply can be open for short time (but arc between positive pole and enclosure should be avoided).
6.Response time (from time of input being available to the output current being up to nominal value): ≤1ms.
7.TTL voltage level control: effective voltage level can be high or low through setting.
8.Protection switch: for detection of cooling water, to protect laser device; or activate with enclosure is opened.
9. Laser power adjustment: (1) by adjusting the output current of power supply through resistor; (2) through PWM control (magnitude being TTL voltage level).
10. Environmental requirements: temperature (-10~ 40℃), relative humidity ≤85%.
Last edited: