- Joined
- May 4, 2009
- Messages
- 5,426
- Points
- 113
Diode Extractor press, pushes the diode out
This press will push out your old diode with out hurting it, the press is $13.00 plus postage.
5.6mm Extractor Press
A new 9mm Extractor press is now available
This press will push out your 9mm laser diode with out hurting it so you can use it some where else
They are made with cold rolled steel so they are very hard and will last a long time, they are $13.00 each plus shipping.
9mm Extractor Press
Well it's finally here a 3.8mm diode extractor press, they are so small and thin on the working end so you will have to be kind to it
no gorilla tactics or they wont last, the problem is that there is a very small space between the laser diodes can and the wall of the heat sink.
They are $13.00 each by them self's and do come with a discount if you buy them in a set.
3.8mm Extractor Press
With a diode setting in it.
You can see the diode is off to one side (bad module) and this extractor press still got it out with no damage to
the press and only a scrape on the side of the diodes can.
Pressing out the diode.
This is how far the extractor comes through the module.
I have two different types of 3.8mm copper modules they are different the one on the right has a smaller hole for
the press to fit through so the press was made to fit this tighter one.
Here is a link to some other fine laser tools> http://laserpointerforums.com/f39/flaminpyros-stuf-67118.html#post966672
This press will push out your old diode with out hurting it, the press is $13.00 plus postage.
5.6mm Extractor Press
A new 9mm Extractor press is now available
This press will push out your 9mm laser diode with out hurting it so you can use it some where else
They are made with cold rolled steel so they are very hard and will last a long time, they are $13.00 each plus shipping.
9mm Extractor Press
Well it's finally here a 3.8mm diode extractor press, they are so small and thin on the working end so you will have to be kind to it
no gorilla tactics or they wont last, the problem is that there is a very small space between the laser diodes can and the wall of the heat sink.
They are $13.00 each by them self's and do come with a discount if you buy them in a set.
3.8mm Extractor Press
With a diode setting in it.
You can see the diode is off to one side (bad module) and this extractor press still got it out with no damage to
the press and only a scrape on the side of the diodes can.
Pressing out the diode.
This is how far the extractor comes through the module.
I have two different types of 3.8mm copper modules they are different the one on the right has a smaller hole for
the press to fit through so the press was made to fit this tighter one.
Here is a link to some other fine laser tools> http://laserpointerforums.com/f39/flaminpyros-stuf-67118.html#post966672
Last edited:
