Jules
0
- Joined
- May 26, 2008
- Messages
- 89
- Points
- 0
Here is a pic of my Sony 16X DVD Red running at 150ma, the 803T up and running @ 80ma and the DX 30mw Green. I tried a highlighter but it was really old. THen I tried blueing for clothes it didn't fluoresce but did show the beams. Then I painted with it on some GITD stars and plastic thingies you stick to the wall. See if you can spot what is printed on the paper underneath the GITD stuff!
I did almost blow it. I did a great job extracting and mounting into the Aixiz module then tested before screwing on the base. I am using a RCKSTR module for current regulation. I carefully screwed the base on and no joy. Also no current draw from my power supply. I let it sit for a while them unscrewed it and fount the ground trace lifted from the board the went to the ground pin of the diode. I reattached and am planning on not using the base. I am going to get a host tomorrow and put both the red and UV into one case. Oh yea, and get a can of GITD paint...
Put a little youtube together for all of it http://www.youtube.com/watch?v=4_kKr4IgO38
This Forum ROCKS!!!! And thanks to all who helped me along the way
I did almost blow it. I did a great job extracting and mounting into the Aixiz module then tested before screwing on the base. I am using a RCKSTR module for current regulation. I carefully screwed the base on and no joy. Also no current draw from my power supply. I let it sit for a while them unscrewed it and fount the ground trace lifted from the board the went to the ground pin of the diode. I reattached and am planning on not using the base. I am going to get a host tomorrow and put both the red and UV into one case. Oh yea, and get a can of GITD paint...
Put a little youtube together for all of it http://www.youtube.com/watch?v=4_kKr4IgO38
This Forum ROCKS!!!! And thanks to all who helped me along the way